Tech Tip: Direction of Drawing on your Sketch

Charity Head December 5, 2023

We’re commonly asked how to make an area’s dimension labels go inside or outside of an area. You can control how it looks when you’re drawing the sketch.

Watch this video to see how (:50)

Tech Tip

Read On

UAD

UAD 3.6 Focus: Exterior inspection as a comp data source?

Did you drive the comps? The new URAR has a spot in the Data Sources for that. Watch this quick video to see what that looks like in the new UAD. ...

Tech Tip

UAD 3.6 Focus: No more free-form data sources

Data Source fields in the new URAR require picking from a list, and some of these you’ve likely not specified in the forms previously. Check out the ...

The Future of UAD: Freddie Mac Recording Q&A

Q&A Blog: Freddie Mac Session Follow-Up with Joel Baker

Tech Tip

UAD 3.6 Focus: Freddie Mac talks about “Properties Analyzed But Not Used”

This week’s tip is courtesy of Sean Murphy from Freddie Mac, who discusses the use of the new UAD’s section for “comps considered” – the Properties ...