| What’s the best way to know your sketch is accurate BEFORE you leave a subject? It’s to square off your measurements using plot points and .the call to close in TOTAL for Mobile. You can learn more about sketching in TOTAL for Mobile in a free training session. Click here to see our full schedule. |
Read On
UAD
UAD 3.6 Focus: Exterior inspection as a comp data source?
Did you drive the comps? The new URAR has a spot in the Data Sources for that. Watch this quick video to see what that looks like in the new UAD. ...
Tech Tip
UAD 3.6 Focus: No more free-form data sources
Data Source fields in the new URAR require picking from a list, and some of these you’ve likely not specified in the forms previously. Check out the ...
The Future of UAD: Freddie Mac Recording Q&A
Q&A Blog: Freddie Mac Session Follow-Up with Joel Baker
Tech Tip
UAD 3.6 Focus: Freddie Mac talks about “Properties Analyzed But Not Used”
This week’s tip is courtesy of Sean Murphy from Freddie Mac, who discusses the use of the new UAD’s section for “comps considered” – the Properties ...